A 100 amp service can sometimes support a Level 2 charger. The answer depends on how much power the home already needs and how quickly you need to charge. If you have a charger in mind, request an EV charger installation quote or a load assessment.
Start with the charger rating
Unmanaged EV charging is counted at its full equipment load in the dwelling calculation. Use the EVSE rating rather than the branch-circuit breaker rating, and record the units correctly.
A 48 A charger operating at 240 V represents 11,520 W. Its 60 A branch-circuit breaker is a different rating. If the calculator asks for watts, enter the equipment load in watts and verify the supply assumptions.
Compare charging needs with the vehicle's capability, daily travel and available charging time. A higher-rated charger adds more load; it is not automatically necessary for every household.
How much electricity does the home already need?
Include the dwelling areas, heating and cooling, ranges, water heaters and other applicable fixed loads. Include a planned suite or hot tub in the same assessment. The service needs to support the proposed combination, not just each addition considered separately.
Demand factors apply to specified loads under the dwelling rules. Do not apply a general household discount to the EVSE rating. For the suite side, see whether a 100 A service can support a secondary suite.
Estimate your home’s electrical demand with an EV charger
When an EVEMS may help
An electric vehicle energy management system can reduce or pause charging in response to other loads. Whether it allows the existing service to be retained depends on the equipment, controls and installation.
Check the City's current EMS/EVEMS equipment and permit guidance. Accepted equipment and other arrangements can have different submission requirements. Charging time also depends on how much capacity remains available; a full charge by morning is not guaranteed.
The home electrical load calculator accepts EV charging load in watts. It does not model EVEMS operation or check equipment acceptance. Have a managed-charging proposal assessed separately instead of entering an arbitrary reduced EV load.
Compare the available options
1. Charging without load management
Have the proposed charger rating checked against the calculated demand and the existing service. Capacity is one part of the assessment; the branch circuit, equipment and permit requirements still apply.
2. A different charger rating or EVEMS
Compare an appropriately configured lower charging rate with a suitable EVEMS. Confirm the equipment settings and installation requirements, and ask for a quote covering the complete work.
3. A service upgrade
If the proposed loads cannot be accommodated, review the service size and utility capacity. In Calgary, coordinate a service change with ENMAX and the City. Confirm the scope and lead time before ordering equipment.
Permit and installation requirements
Calgary requires an electrical permit for charger installation. A registered electrical contractor must obtain the permit for EV charger wiring or an EV energy management system. The City explains the limits of homeowner electrical permits and lists the documents for each service and equipment type.
Frequently asked questions
Do I need a service upgrade for an EV charger in Calgary?
Not necessarily. Have the existing service and proposed loads assessed. Charger rating, suitable load management and the condition and ratings of the service equipment can affect the options.
Can a 100 amp service support a Level 2 charger?
It may, depending on the other loads and the proposed charger rating. A 100 A main breaker alone does not establish that there is enough capacity.
Can the home electrical load calculator model EV load management?
No. It accepts EV charging watts but does not model energy management or check equipment acceptance. A proposed EVEMS needs a separate assessment.
Do I need an electrical permit for an EV charger?
Calgary identifies an electrical permit for EV charging. Check the current City guidance for application eligibility, inspections and any EMS/EVEMS submission requirements.
Request an EV charger load assessment
Planning information only. Confirm the calculation, equipment and current submission requirements for your project. Final acceptance rests with the authority having jurisdiction.